How to use Spark LINK

Last modified on: 3/15/2024, 5:41:37 PM

Getting started

Connect The Transmitter (TX) To Your Guitar

  1. Plug Spark LINK TX into the output jack of your guitar.
  2. Adjust the hinge so that Spark LINK TX sits comfortably on your guitar.
  3. Press and hold the button to turn on.
Connect Spark LINK TX

Connect The Receiver (RX) To An Amp or Effect Pedal

  1. Plug Spark LINK RX into the input of your amp or effect pedal.
  2. Press and hold the button to turn on.
Connect Spark LINK RX

Operation

Connect Spark LINK TX

Pairing Spark LINK We TX and Spark LINK RX

Spark LINK TX and Spark LINK RX will automatically pair once both are turned on. The LED will flash blue while pairing and once paired, will show battery status. You can connect up to four Spark LINK setups for simultaneous jamming within the same space.

Re-Pairing Spark LINK TX and Spark LINK RX

While both powered on, double-press the button on Spark LINK TX to scan and re-pair to Spark LINK RX.

Muting Spark LINK

Quick-press the Power button on Spark LINK TX to mute and unmute. The LED will flash yellow and green.

LED Indicator

The LED will flash blue while pairing and once paired, will show battery status.

LED ColorStatus
BlueTX / RX Pairing / Connecting
GreenBattery Level : 60% - 100%
YellowBattery Level : 6% - 60%
RedBattery Level : Below 5%

Plug Spark LINK TX and Spark LINK RX into a USB power supply with the USB cable provided. It is recommended the power supply be 5V-1A.

Charging Spark LINK

While charging, the LED indicator on both devices will display battery level.

Auto Power Management

If there's no signal for 15 minutes, Spark LINK TX will automatically turn off to conserve battery. Spark LINK RX will likewise turn off after 15 seconds if it detects no connection to Spark LINK TX.

LED ColorCharge Status
Flashing RedBelow 5%
Flashing Yellow6% - 60%
Flashing Green60% - 99%
Solid Green100%

Manual Power Reset

If you encounter any issues with Spark LINK that render it unusable or shut down properly, you can resolve the issue by performing a manual power reset:

  1. Locate the reset button inside the small hole on the side of Spark LINK.
Manual Power Reset
  1. Use a needle or paperclip to gently insert into the reset button hole.
    Press the reset button once to reset power.

Was this page helpful?